Installation Instructions

ManualsBrandsJS International ManualsBathJSI Danbury 15"W x 21"D White Bathroom Vanity Cabinet

Vanity Cabinet

Assembly Instructions

This assembly instruction applies to VDW-V3621D-R and VDW-V3621D-L

485 Commerce Dr.

Fall River, MA 02720

Parts included:

Cabinet Items Qty

A Face Frame with Door

1 x

Side Panel

(Left and Right)

2 x

C Bottom Panel

1 x

D Back Panel

1 x

E Toe Kick

1 x

F Drawer Front

3 x

Drawer rails set

(left and right)

3 x

Drawer rail

Holder

6 x

Tools needed for assembly:

Drawer Items Qty

I Drawer Bottom

3 x

J Drawer Sides

6 x

K Drawer back

3 x

½” Flat Head

Screws

6 x

1 3/8 Drawer

Bolt / Cylinder

12 x

x 12

1/2'' Rail Boot

Screws

12 x

3/4'' Drawer

Bottom

Screws

6 x

Cam lock cap

Cam lock pin

10 x

Philips screwdriver

Summary of content (5 pages)

PAGE 1
485 Commerce Dr.
PAGE 2
Step #1: Check & Count Check and count the items in the box before installation. If you are short any pieces, stop and call your supplier. Otherwise, follow the steps below. Step #2: Set-up P Put the face frame (A) face down on a flat soft working surface (Figure 1). Use screw driver to screw the cam lock pins (P) in the pre-drilled holes on the frame.
PAGE 3
Step #4: Install Bottom Panel Install the bottom panel (Figure 4): Gently spread side panels and insert bottom panel (C) into the grooves of side panels (B) until it touches the face frame (A). B B A Figure 4 D Step #5: Install Back Panel & Toe Kick Install the back panel and toe kick (Figure 5): Screw the cam lock pin (P) to the back side of the side panels (B). Then put the back panel (D) at rear of side panels (B).
PAGE 4
Step #7: Drawer Assembly Drawer assembly: place the drawer-face (F) face down on a flat soft working surface. Insert the screw cylinders (M) into the outer holes on the back of the drawer face (F) and drawer back (K) (Figure 7). M F K Figure 7 Step #8: Drawer Assembly Align the two drawer sides (J) with the drawer head and insert bolts (M) through the holes on the side panels into screw cylinders (Figure 8).
PAGE 5
Step #10:Drawer Assembly To secure the drawer bottom panel, use ¾ Drawer Bottom Screws (O) and screw them into the predrill holes on the bottom panel (Figure 10) Repeat these steps for additional drawers. Figure 10 Step # 11: Drawer Assembly Install outer rail to the cabinet frame by pushing the rails into the drawer rail holder.