Installation Instructions

Vanity Cabinet

Assembly Instructions

This assembly instruction applies to VDW-V3021 and VDW-V2421

485 Commerce Dr.

Fall River, MA 02720

Parts included:

Cabinet Items

Qty

Face Frame with Door

1 x

Side Panel

(Left and Right)

2 x

Bottom Panel

1 x

Tools needed for assembly:

Philips screwdriver

Drawer Items

Qty

Back Panel

1 x

Toe Kick

1 x

Cam lock cap

Cam lock pin

10 x

Ste

PAGE 1
485 Commerce Dr.
PAGE 2
#1: Check & Count Check and count the items in the box before installation. If you are short any pieces, stop and call your supplier. Otherwise, follow the steps below. Step #2: Set-up P Put the face frame (A) face down on a flat soft working surface (Figure 1). Use screw driver to screw the cam lock pins (P) in the pre-drilled holes on the frame.
PAGE 3
Step #4: Install Bottom Panel Install the bottom panel (Figure 4): Gently spread side panels and insert bottom panel (C) into the grooves of side panels (B) until it touches the face frame (A). B B A Figure 4 D Step #5: Install Back Panel & Toe Kick Install the back panel and toe kick (Figure 5): Screw the cam lock pin (P) to the back side of the side panels (B). Then put the back panel (D) at rear of side panels (B).