Installation Instructions

Step #12:

Place drawer box front on a soft surface. Gently, put wood glue in each one of the dovetails. Line up the

dovetails and pressed them to lock. Insert the drawer box bottom into the groove between the sides.

Insert the drawer box back and press the sides to lock. Using rubber mallet, gently tap the sides to get

smooth dovetail joint. Use four of 1” screws (Q) on pre-drilled holes to secure the dovetail joint in place.

Step #13:

Install the drawer front: Use the 7/8” flat head screw (T) to drive them trough the drawer box front. Put the

drawer front (F) on soft surface. Align the pre-drilled holes on the drawer front with the pre-drilled holes and

screw on the drawer box.

Step #14:

Install the drawer clips: first flip drawer box upside-down. Place the drawer clips (M) in the corner next

to drawer front. Use three 1/2” flat head screws (P) to screw each drawer clip in place. All screws must

go at 45 degrees to be screwed at the drawer box front and sides.

Step # 15:

To install drawer, simply pull both drawer rails completely out. Align the notches on the back of the

drawer box with the drawer rails. Push the drawer box down and close it completely. Open the drawer

and check if drawer rails are locked in place. If rails are not locked push them with hand to lock in

place.