Manualshelf

Installation Manual

ManualsBrandsJRE ManualsDeadboltsElectric Magnetic Lock Bolt JRE01 : Complete Door Access Control System : Securely Buzz Visitors in Or Out Remotely : Flush Magnetic Drop Bolt Kit
1234
Dropbolt does not activate when
the door closed.
Low in voltage / current.
Low in voltage / current.
Make sure the output voltage and the current
draw are large enough for pull in 0.9A/12VDC.
Make sure the output voltage and the current
draw are large enough for pull in 0.9A/12VDC.
Lock and unlock sensor rating
1A/24VDC
Door position status rating
0.5A/20VDC
Lock and unlock sensor rating
1A/24VDC
Door position status rating
0.5A/20VDC
Door opened= N.C.
Door closed=N.O.
Copyright
P-MU-EB-S Ver.J Published on 2011.08.22
© Gianni Industries, Inc. All Rights Reserved.
Make sure that the “+” and “-” wires are connected correctly. Failure to observe polarity will result in a short circuit and is not covered
by product warranty.
Caution:
0 second 3 seconds
6 seconds
0 second 3 seconds
6 seconds
0 second 3 seconds
6 seconds
Adjust the door closer or the door hinge for the
door leaf to close the door in the correct
position.
If solution 1. doesn’t work, it is recommended
to change the double action door to single
action door.
Release or sway the door to release the latch
bolt to open the door.
If solution 1. doesn’t work, it is recommended
to change the double action door to single
action door.