Operating Manual

5/17
4. Function
It has the following control function.
(1) Communication function with mail server.
Mail transmission and reception are performed between this device and a mail server.
(2) Information notification function at set time (linkage function with server)
Voluntarily notify information to the server at the set time (daytime batch,
nighttime batch)
(3) Alarm notification function (linkage function with server)
It notifies information to the server autonomously according to the event generated
by this equipment. The types of events are as follows.
a) Intrusion alarm function
b) Out-of-area alarm (generation / release) function
c) Battery disconnection alarm (generation / release) function
(4) Command reception processing function
To perform processing to a command transmitted from a server.
Command reception processing function
a) Machine status inquiry function
b) Intrusion alarm effective time setting function
c) Area setting function
d) Communication stop / resume function
e) Communication test function
f) Communication capacity confirmation function
g) Calendar change function
h) Time difference setting function
(5) Communication function
It has the following functions to communicate with the server.
a) Destination setting (fixed)
b) Batch transmission timing
c) Retry transmission
(6) Operation time acquisition function
While the hour meter signal is ON (while the engine is in operation), the time is counted,
and the count value is integrated. Get the total operating time. Note that total operating
time is stored in nonvolatile memory.
(7) GPS information acquisition function
Acquisition of GPS information shall be made every 30 minutes (0 minutes, 30 minutes
per hour). After starting the device, the GPS module is started immediately.
When the GPS information can be positioned normally, the date and time of the GPS
information is reflected on the RTC of the apparatus. When the positioning fails,
the RTC is not updated. The time correction shall be implemented 24 hours after
the previous implementation times. Positioning satellites (NMEA sentences) shall be
GPS only (GLONASS is not used). GPS data is received (application acquires data)
At ｔｈe time of GPS positioning. However, when the application does not perform
positioning even after one minute has passed from the GPS information acquisition time
(start), the acquisition processing is ended as non-positioning.
(Surveyor system: WGS-84)