Installation Guide

12
3. Drill two .4in/10mm diameter by 2.8in/70mm deep holes in the wall at the marked
locations.
4. Insert the expansion screws and fasten.
5. Check the up/down direction of the installation bracket, and then fix it to the
wall with expansion screws on wall.
6. Refer to pole installation steps, fix the eNB on the wall bracket.
7. Proceed to “3.5 Connect Cable”.
Connect Cable 3.5
3.5.1 Cable Laying Requirements
General requirements:
 Bending radius of feeder cable: 7/8” > 250mm, 4/5” > 380mm.
 Bending radius of jumper cable: 1/4” > 35mm, 1/2” (super soft) > 50mm, 1/2”
(ordinary) > 127mm.
 Bending radius of power cable and grounding cable: > tripled of the diameter of the
cable.
 The minimum bend radius of the optical fiber is the 20 times the diameter of the
optical fiber.
 Bind the cables according the type of the cable, intertwining and crossing are
forbidden.
 An identification label should be attached after the cable is laid.
Optical fiber laying requirements:
 Avoid circling and twisting during the laying.
 Avoid binding on a turn.