Installation Guide

11
4. Tighten two screws on the top of the bracket to complete the installation.
5. Proceed to “3.5 Connect Cable”.
Install on Wall 3.4
Ensure that the wall can bear at least 4 times the weight of the eNB. The wall should be
made of bricks or concrete, and concrete is recommended.
Follow the steps below to install the JRL-113BT48 eNB on the wall.
1. Take apart the assembled installation bracket kit to get the installation bracket.
2. Against the installation bracket on the wall, with the arrow pointing up. Mark the
drilling locations using a pencil or marker.