Installation Guide

10
NOTE: The eNB may adopt different models of GPS antenna, so the GPS antenna may not the same
as above figure. But the installation steps that fix it on the eNB is the same.
Install on Pole 3.3
The eNB mounting bracket is assembled in manufacturing before packing. The only
action required by the installer is to fix the assembly on the pole.
Check to ensure the diameter of the pole is in the range of 1.6-3.9 inches (40-100 mm).
The position of the eNB on the pole should be at least 47 inches (120 cm) in height.
Follow the steps below to install the eNB on a pole.
1. Unscrew the 4 screws of the assembled bracket. Slide the two omega clamps to the
left, and then turn them up or down.
2. Against the bracket on the pole, considering the height requirements described
above. Fit the threaded rod of the bracket to the pole, and then turn the 2 clamps to
the proper position. Fasten with the 4 screws.
3. Align the pin on the eNB bracket to the pin holes on the pole bracket, lower the pin
into the pin holes vertically until the hook on the eNB gets stuck firmly with the slot
on the pole bracket.