Installation Guide

6
2. Installation Preparation
Support Materials 2.1
In addition to industry standard tools, you will need the materials described in Table 2-1
during the installation. When selecting an RF antenna, be sure to match the frequency
range of the antenna with the eNB.
Table 2-1 Support Materials
Item
Description
Power cord
The diameter of power cable must be AWG15 or greater (such
as AWG14). And the length from the power adaptor’s DC end to
the eNB must be shorter than 100 meters (~109 yards).
Power plug
The power plug connecting to the electricity supply.
Antenna RF cable
50 ohm feeder
Optical fiber
Single mode optical fiber
Ethernet cable
Outdoor CAT6, shorter than 100 meters
Antenna
Omnidirectional, or directional antenna
Ground cable
The diameter of grounding cable must be AWG15 or greater.
Installation Tools
2.2
The following tools are needed during the installation.
Level bar
Marking pen
Knife
Vise
Wrench
Percussion drill and
some drill heads
hammer
Cross screw
driver
Cable vice
Tape measure
5mm L-shape allen
wrench
T7 screwdriver
head
Ladder