Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
3-3
３
POWER
TX
STBY
POWER
POWER
TX
STBY
1 Check that the ship’s mains are turned on.
2 Press .
Orange lamp on
→
The warm-up time will appear.
3 Wait for completion of warm-up
When the warm-up time expires, the warm-up time screen disappears and
the PREHEAT display on the upper-left corner of the radar display is
changed to STANDBY .
4 Press .
The radar transmission and the scanner start rotating.
The STANDBY on the upper-left corner on the radar display is changed
to TRANSMIT .
Attention: Even if is pressed before STANDBY is displayed, radar
transmission is not performed.
The method of transmission in case of emergency.
1 Check that the ship’s mains are turned on.
2 Press .
Orange lamp on →
The warm-up time will appear.
3
A push of the
5 seconds or more vanishes the display of
warm-up time.
The radar transmission and the scanner start rotating.
The STANDBY on the upper-left corner on the radar display is changed
to TRANSMI
Note:
In the moment sag of a power supply, and the case of an unusual
operation outbreak, it can transmit, immediately after rebooting the power
supply.
Please do not use emergent transmitting operation except the above.
The life of a magnetron will be shortened if the warm-up is not completed.
Procedures
POWER
TX
STBY
Procedures