Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
A-2
APPENDI
X
① Click MENU , then SUB1 MENU
① Click ISW .
① Click the pattern selection menu number.
Click SET .
② Click EXIT .
① Click EXIT .
① Click MENU .
The radar will be placed in
the standby mode. The
changed pattern diagram
in the center of the display
as well as the change
menu at the right of the
display will be displayed.
① Click the
on the upper left of the screen.
(This software button is differing in
selecting pattern. This picture is
2UNIT, No.4.)
2. OPERATIONS
When switching over the interswitch patterns, first set the system to the STBY mode and
proceed the switch operations on the operation panel of the Display Unit as shown in the
operation flow below.
2.1 Operation Flow･･････････････････････････････････････
The following flowchart shows the operation flow from menu opening to menu closing.
〔Closing the interswitch menu〕
〔Open of the Sub1 Menu〕
〔Changing interswitch patterns〕
〔The ISW Menu will appear〕
〔The Sub1 Menu will be closed〕
〔Open of software button〕