Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
3-96
３
5 Click TURN MODE.
TURN MODE will be selected.
Select any turn mode.
RADIUS: Constant turn diameter (NM)
RATE: Constant turn speed (deg/min)
6 Click the numeric setting section of TURN SET .
TURN SET will be selected.
The numeric input dialogue box is opened.
7 Set the numeric value in the dialogue box.
8 Press END .
Note: If the initial setting is not correct, the maneuver curve will be
affected.