Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
3-58
３
Marking [MARK]･････････････････････････････････････････
A maximum of 20 marks can be displayed at arbitrary positions on the radar video.
A mark created on the display holds the latitude and longitude.
①
[I] Plotting Marks. CURSOR( )
1 Place the cursor over the upper right section of the screen
(right figure), then right-click. Next, select "MARK".
MARK will appear in the CURSOR（ ） at the upper left of the radar display.
2 Put the cross cursor mark [ + ] on the position where the [□]
mark is inserted.
3 Press trackball section left button.
The cross cursor mark [ + ] will be changed into the [□] mark and fixed on the
radar display. When entering more [□] marks, repeat the procedures from step
2. Up to 20 marks can be entered.
Note: If more than 20 marks are created, the oldest mark is cleared and the newly
created mark is displayed.
①
[II] Clearing Marks CURSOR( )
1 Place the cursor over the upper right section of the screen
(right figure), then right-click. Next, select "MARK".
MARK is displayed on CURSOR（ ） at the upper right of the radar display.
2 Put the cross cursor mark [ + ] on the position where the [□]
mark is inserted.
3 Press trackball section right button.
The [□] mark will disappear. When clearing another [□] mark, repeat the
procedure from step 2.
Procedures
Procedures