Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
5-7
５
5.2 DISPLAY MODE SETTING
Setting Motion Display Mode [TM/RM]･･････････････････････
Press RM(R) / TM button on the upper left of the screen, then select the true motion (TM) display
mode or the relative motion (RM) display mode.
In the initial state, the mode is set to RM.
Note━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
For further details on the TM/RM modes, refer to section 3.4 “Select True/Relative Motion
Display Mode.”
Setting Bearing Display Mode [AZI MODE]･･･････････････････
Set the bearing display mode by pressing N UP/H UP/C UP on the upper left of the screen.
Note━━━━━━━━━━━━━━━━━━━━━━━━━━━━━
For further details on the TM/RM modes, refer to section 3.4 “Select True/Relative Motion
Display Mode.”