Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
8-35
８
Procedures
Bearing Adjustment･･･････････････････････････････････････
Adjust the bearing so that bearing of the target measured with the ship’s compass
corresponds to that of the target echo on the radar display.
1 Press the “N UP/H UP/C UP” button on the upper left of the
screen, then change the bearing display to relative display
(H UP) .
2 Measure the bearing of an adequate target (for example, a ship
at anchor, a breakwater or a buoy) relative to own ship’s
heading. (For instance, assume that the bearing of the target
is 25°.)
3 Click MENU on the screen. Or press
OPTION2 key.
The MAIN Menu will appear.
4 Click CODE INPUT .
The CODE INPUT Menu will appear.
5 Click 0 , then END .
The ADJUST Menu will appear.
6 Click the “2.BEARING”edit box.
2.BEARING will be selected.
7 The EBL for bearing adjustment will appear.
Rotate the [EBL] control and adjust EBL to the target selected
in Step 2 above.
Press [EBL] control to set it.
8 Rotate the [EBL] control and adjust the EBL for bearing
adjustment to the bearing of the target selected in Step 2
above.
Press [EBL] control to set it.
(Adjust the EBL bearing to 25°as the instance in Step 2 above)
9 Repeat the procedures from step 5 above if the bearing is not
completely coincident with the target's actual bearing.
ADJUST
1.TUNE
2.BEARING
０．
EXIT
0-127
1.5
3.CPA RING
4.ANTENNA HEIGH
0.0-359.9゜
10
ARPA/AIS
5.
000.0
0-999
SECTOR BLANK
MBS
6.
7.
3.OVER 25m