Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
3-66
３
The process setting items of FUNC4 and FUNC5 can be changed by service personnel.
• Setting gain of input target signal (sensitivity preset)
• Setting standard value of input target signal (noise level)
• Setting radar interference rejection (IR):IR1 to IR4 (Effective when IR is ON)
• Setting target enhancement (TGT ENH):EXP1 to EXP4 (Effective when TGT ENH is
ON)
• Setting target processing (PROCESS):MODE1 to MODE8 (Effective when PROCESS
is ON)
• Setting sensitivity range (Maximum and minimum values)
• Setting sea clutter suppression range (Maximum and minimum values)
• Setting rain/snow clutter suppression range (Maximum and minimum values)
Note: Do not use FUNC2 and FUNC3 on short ranges. Otherwise, detection of ship targets
moving high speeds may become poor.
For FUNC1 to FUNC3, the recommended parameters have been preset by the
manufacturer, but the preset parameters could no be changed after delivery. In using
FUNC1 to FUNC3, IR, TGT ENH and PROCESS shall be set to ON (PROC1 to PROC3).
Expand Targets･･････････････････････････････････････････
Targets displayed on the radar display can be expanded, regardless of the pulse length selected.
The "ENH" section at the button left
of the screen can be clicked to
change the ON/OFF setting.
1 Click MENU.
The Main Menu will appear.
2 Select "ON" radio button of
TGT ENH .
“ON”in“2TGT ENH”will be set and“ENH
ON ”will appear at the lower left of the radar
display.
Then, the targets on the radar display will be
expanded for higher definition.
1 Click MENU.
2 Select "ON" radio button of TGT ENH.
“OFF” in “2.TGT ENH” will be set and “ENH OFF” will appear at the lower left
of the radar display.
The expanded targets on the radar display will be reset to their original sizes.
1 Click EXIT .
The Main Menu will be closed.
Procedures
Cancellation
Exit
MAIN MENU
1.IR
CENTER
2.TGT ENH
０．
EXIT
OFF
ON
OFF
ON
3.PROCESS
2.PROC1
4.FUNCTION
1.FUNC OFF
5.EBL1
OFFSET
6.EBL2
CENTER
OFFSET
DATA OFF
SUB1 MENU
CODE INPUT
7.
8.
9.