Operation Manual

● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
3-65
３
FUNCTION･･･････････････････････････････････････････････
FUNCTION is a function of setting the process suited for each condition during navigation to
enhance the target detection performance.
Setting items: The following nodes can be switched over.
FUNC1: Effective in observing the echoes on short ranges.
FUNC2: Effective in observing the echoes on long ranges.
FUNC3: Effective in observing the echoes in rough weather.
FUNC4: Set by service personnel. The initial setting is the same as FUNC1.
FUNC5: Set by service personnel. The initial setting is the same as FUNC1.
1 Click the MENU on the screen.
The Main Menu will appear.
2 Click FUNCTION.
4.FUNCTION will be selected and the
pull-down menu will appear.
3 Select a desired process setting
item from the click.
The process setting item will be changed and
the current setting state will appear at the
lower
right of the radar display.
4 For changing the setting item, open
the pull-down menu in step 2 above
again and select a desired process
setting item.
1 Click EXIT .
The Main Menu will be closed.
1 Execute the procedures to function up to step 2.
4.FUNCTION will be selected and the pull-down menu will appear.
2 Click EXIT .
1.FUNC OFF will be set and “FUNC OFF” will appear the lower right of the
radar display.
Procedures
Cancellation
MAIN MENU
1.IR
CENTER
2.TGT ENH
０．
EXIT
OFF
ON
OFF
ON
3.PROCESS
2.PROC1
4.FUNCTION
1.FUNC OFF
5.EBL1
OFFSET
6.EBL2
CENTER
OFFSET
DATA OFF
SUB1 MENU
DEGAUSS
7.
8.
9.
1.FUNC OFF
2.FUNC1
3.FUNC2
4.FUNC3
5.FUNC4
6.FUNC5
Exit