Users Manual
Operation
4-23
5
5
5
.
.
.
Touch the [CALL] button to send the call.
After checking the free channel condition, sends the
message. After sending the call, waits for the
acknowledgement for 5 sec.
If received no response within 5sec, sends the
call once again. If there is still no response,
this call is ceased.
6
6
6
.
.
.
After received the acknowledgement, the specified
working channel is set.
After the channel changing, a start of call is sent.
If the channel engaged signal is lost, this call
is terminated.
7
7
7
.
.
.
The PSTN connection is completed.
Lift the handset from the cradle and wait for the recipient
answering the phone (the PSTN dial tone and ring tone
from the handset is heard at this time). After answered
the phone, the phone call charge is started.
If not answered within 1 minute, this call is
terminated. (It may be similar in the case of
bad radio link condition during
communication.)
8
8
8
.
.
.
To finish the phone call, return the handset to the
cradle.
Additionally, the duration is received from the coast
station and is displayed as the DUR. The example at right
shows 13 minutes and 45 seconds.
- According to the coast station, the “unable to comply” acknowledgement
mentioned above may be received at step 6.
- If the “unable to comply” acknowledgement indicates “Queue” reason, the wait
mode can be selected. The mode enables to continue the above procedure from
step 6 after receiving the ring back call. (However, if receiving no call within 15
minutes after receiving "Queue", the ring back mode is canceled. Or if the
[CH16] button is touched, the ring-back mode is also cancelled.)
Note
Note
Note
Note