Users Manual

Operation
4-9
4.2.4 Receiving with scanning
Scanning function enables to watch multiple channels (additional channels) with the priority
channel (CH16). If found receiving signal on the additional channels, the dwell time on that
channel will be longer, but continued to watch the CH16 alternatively. The scan mode can be
selected from the following modes.
All CH scan Mode: Scans all channels in the current channel mode.
Memory CH scan Mode: Scans all memory channels.
Select CH scan Mode: Scans the specified range of channels.
Procedure
1
1
1
.
.
.
From the main menu, touch the [CH OPE] [SCAN]
buttons.
2
2
2
.
.
.
Touch the menu button of the scan mode to select.
Incase of the [ALL CH] button or the [MEMORY CH]
button, the scan starts immediately.
Incase of the [SELECT CH] button, the screen at right
appears and set the channel range as follows.
1) Input the start channel (FROM:) and the stop
channel (TO:).
2) Touch the [EXE] button to start scanning as
shown at right.
- Disabled to scan when the channel region
is Inland Waterways (IWW).
- CH70 is skipped, even if contained in the
scanning range.
3
3
3
.
.
.
Touch the [SCAN STOP] button to stop scanning.
After terminated, the radiotelephone is set on the
last stopped channel. (The example at right shows
when stopped on CH12.)
Scanning is also terminated when off-hook or
PTT ON is detected.
- While scanning, the radiotelephone scans CH16 and the additional channels
alternatively in a cycle of 0.14/0.86 seconds.
- If the squelch is opened on the CH16, paused scanning and continues to watch
on the CH16. If squelch is closed again, the scanning will resume 2 seconds
later.
Note
Note