Users Manual

Operation
4-7
(3) Setting a 4-digits channel (Incase of the CH1020)
1
1
1
.
.
.
On the status display or operations screen, touch
the channel display area or the ten-key icon
button to indicate the numeric keypad.
2
2
2
.
.
.
Touch the [1] button.
“1” is appeared. Then if left for more than 1 second, the
hyphen is appeared and starts flashing as shown at right.
3
3
3
.
.
.
Touch the [0] button.
CH10 is set, first.
4
4
4
.
.
.
Touch the [2] button within one second.
The 4-digits display form at right is appeared. Then if
left for more than 1 second, the hyphen is appeared and
starts flashing as shown at right.
5
5
5
.
.
.
Touch the [0] button.
Setting of the CH1020 is finished.
When the hyphen is flashing, if left without inputting a figure for 2 seconds, the channel
returns to the previous value. Additionally in the above example, if the 3 digits are input
and the hyphen is flashing at the ones place digit for 2 seconds, then the channel returns
to the CH10 which is temporarily set in this procedure.
1-
10
10
2-
10
20
-
Note