Users Manual
Settings & Registrations
5-2
5.2 Own ship position and time setting
Normally, the ship's position and the time are updated automatically if importing GPS information.
But if necessary, input these parameters manually as follows.
■ Procedure ■
1
1
1
.
.
.
From the main menu, touch the [SETUP] →
[POS/TIME] buttons.
2
2
2
.
.
.
Set the SOURCE menu to MAN to input the ship
information manually.
3
3
3
.
.
.
After inputting the position and the time, touch the
[✓] button to save them.
This menu includes the following settings
1. OWN POSITION
SOURCE: Select ship position source from below.
MAN ········ Manual input
GPS ········ External positioning system
CLEAR ····· No selection
COORDINATE: NE/ NW/ SE/ SW
LATITUDE/ LONGITUDE:
2. UTC OF POSITION
3. STATE DISP
DISP TYPE: Select the display type of information on
the ship position source from below.
NORMAL ··· Ship position source selected on the SOURCE menu
QUALITY ·· Positioning system and the type of quality
(For more details, see "9.4 Peripheral interfaces (1.3)".)
- After the position and the time information are input manually, that information is
not overwritten with an external device, such as a GPS, automatically.
- If using the external positioning system information after manually inputting data,
set the SOURCE menu to “GPS”.
- If the position and the time information are not received within 10 minutes after
powering on, or after 10 minutes elapsed since interrupted, the alarm screen
may appear. Further, regardless of either manually or automatically if not
updated the position and the time within 4 hours after the last entry, the alarm
screen also appears.
- If the position and time is not updated for over 23.5 hours, that information is
automatically erased and notified by a popup display and an alarm sound.
Note