Users Manual

Operation
4-46
4.6.4 Intercom
If one or more controllers (NCM-980) are connected to the main unit (JHS-800S), the intercom is
available between two units of the main unit and/or the controller(s).
While the intercom is in use,
the received voices will not be recorded even if the squelch is opened.
(1) Calling and talking
■ Procedure ■
1
1
1
.
.
.
Lift the handset from the cradle and then touch the
[MENU]→ [VOICE FUNC]→ [INTCOM] buttons.
 The main unit and controllers list is displayed.
 The example at right shows that the following
controllers are connected.
- Address 1: Calling main unit
- Address 2: Station.02
- Address 3: Station.03
- Address 4: Station.04
- Address 5: Not connected
2
2
2
.
.
.
Touch the button of the controller to call.
 The screen at right is displayed and the intercom call
is started.
 Replacing the handset on-hook while calling finishes
calling and returns to the status display.
 Touching the [CANCEL] button while calling finishes
calling and returns the screen to the step 1.
- If the handset of the recipient is left off-hook,
the call is not started and the screen at right
is displayed. Then touch the [FINISH] button
to finish calling and return to the step 1.
.
- If not answered within 30 seconds, the
screen at right is displayed. Then touch the
[OK] button to return to the step 1.
3
3
3
.
.
.
After answered the phone, the screen shown at right
is displayed and enabled to start the communication.
 Press PTT key to talk.
 To finish the intercom, touch the [FINISH] button or
replace the handset on-hook.
Note