User Manual

Servo Travel Adjustment with the Travel Limiter Pot
The G7000T features both Left and Right manual servo travel limiter pots located on the end of the Amplifier unit as shown in
the diagram. This manual setting allows you to use a full 150% travel value in your radio setup for the best resolution, while being
able to reduce the physical travel of the servo in each direction to remove any tail linkage binding.
To set the physical travel of the servo, move the servo via the transmitter stick to its extreme Left/Right positions while looking
at the tail pitch control slider on the back of the model. If there is visible clearance at maximum travel in each direction, increase
the respective servo travel limiter pot until maximum travel in each direction is achieved. If binding is occurring in either direction,
reduce the travel limit pot for the desired direction as needed until binding is removed.
-7-
Tail Lock/Rate Mode Selection via AUX Channel
Channel Selection
PCM 10 Series: Aux 2 Channel
7-to 9-Channel Systems: Gear Channel (CH5)
Unlike most gyro systems, the G7000T’s design utilizes a separate AUX channel for activation and adjustment of the 2 modes of
operation: Tail Lock and Rate mode. The second AUX channel for the Mode selection must be connected to an auxiliary channel of
the receiver and adjusted to insure proper operation of the G7000T.
Servo Travel Limiters