User Manual

Radio Type Polarity Connections

Please refer to the following polarity color chart when

connecting the JR

G7000T to a brand of radio system other

than JR. Please note that if the system is connected incor-

rectly, the G7000T will not function, but no damage will occur

to any of the radio components. After successful connection,

secure the gyro to the servo connection with a small piece of

tape to prevent possible disconnection during use.

-5-

Final Connections

Connect the JR G7000T Gyro to your radio system.

Step 1: Insert the AUX connector (white) to the AUX

channel on the receiver as follows:

PCM 10 Series: AUX 3 Channel

7-to 9-Channel Systems: AUX 2 Channel

Step 2: Connect the desired servo to be used into the

Black female connector lead labeled “Servo.”

Step 3: Connect the black connector labeled “Select” to the

AUX channel on the receiver as follows:

PCM 10 Series: Aux 2 Channel

7-to 9-Channel Systems: Gear Channel (CH5)

Setup

Initial Gain, Travel Adjust, Dual Rate, and Expo Settings

Please use the following settings as a starting point for

initial test ﬂights. After some experience and ﬂight time is

gained, these values can be adjusted to suit your preference.

Travel Adjust

Left Rudder ....................150%

Right Rudder ..................150%

Dual Rates .......................Low Rate 60% /High Rate 100%

Exponential Values .........30%–60%

Gyro Gain Values ............Hover: 65%–80% Stunt: 40%–55%