User Manual

Mounting the G7000T

Be sure to thoroughly clean the G7000T’s mounting area

and the helicopter’s mounting location with rubbing alcohol

prior to attachment.

Note: Never install/mount the G7000T sensor directly to

bare wood as it is possible for it to loosen during ﬂight.

Always seal the wood surface with paint, epoxy, or CA

adhesive prior to mounting.

-3-

Metal Shield Plate for SRV Gyro (Option)

This Shield Plate alleviates the potential for electro-

magnetic noise caused by devices such as servos, electric

motors, ESCs, etc.

Installation

Set the Shielding Plate between the Gyro (Sensor) and the

mounting surface of the helicopter using the included

adhesive tapes. Please follow the mounting suggestions

below for additional mounting information.

Mount the G7000T’s sensor and ampliﬁer with the labels

facing upward. Please note that the sensor unit must be

mounted so the sides of the unit are 90° to the center line of

the fuselage.

Shielding

Plate

Gyro (Sensor)

Adhesive tape