User Manual

the roller. Rotate the roller to select the time of delay to slow the servos movement. Set this as desired.
Then press down on the roller when complete.
Servo Speed
Scroll with the roller until SRV.Speed is highlighted, and press down on the roller to enter this function.
In this function you can adjust the speed of response of each of the 9 channels. It is recommended to
leave channels 1–4, as well as channels 7 and 8 set at NORM as these are the primary flight control
channels, and should be left at maximum speed to avoid slow responding controls. This function can be
used to adjust both flaps to deploy at the same speed if there are variations in the servo speeds, and can
be used to further slow the flap servos if the Delay option in the flap system is not used or a further
delay is desired on the flaps. With most mechanical retract servos; it will not be possible to adjust the
gear speed. If using a system that allows the gear speed to be adjusted, you can do this here. To adjust
the speed of a channel, scroll with the roller to select the channel and direction of movement you wish to
adjust, press on the roller to select it, then rotate the roller to adjust the value. Press down on the roller
when the desired value is set.
Timer
Scroll with the roller until TIMER is highlighted, and press down on the roller to enter this function. In
this function you can activate a flight timer, by scrolling with the roller until INH is highlighted and
pressing down on the roller. There are 2 options available, one is a down timer which will count down a
pre-set time period and beep at the end of the time to let you know to land. The other option is a
stopwatch, which will count the amount of time since the timer key was pressed. Select the option
desired. If the down timer is selected, you can set the length of time by highlighting the time and
pressing down on the roller, setting the time with the roller, then pressing down on the roller to select the
time. The timer will be on the trainer button and/or the lower left key beside the screen.