User Manual
JR XP9303 Programming Guide for the Hangar 9 1.50 Size P-51
By Danny Snyder
This guide will assist in the programming necessary to set up the 1.50 Size Hangar 9 P-51
Mustang, though the information could be used on many other scale type models with some
modifications where necessary. To start with, plug your servos into the correct channels. Below is a
listing of what servo to plug into each channel. You will need a 9-channel receiver to use the setup
described below. Additional Y-harnesses or matchboxes will be required if using a receiver with less
than 9 channels for the gear, flaps and/or elevator.
Ch. 1 Throttle
Ch. 2 Right and Left Aileron w/ Y-Harness or Matchbox (to be consistent with use of initial 1
st
caps)
Ch. 3 Right Elevator
Ch. 4 Rudder
Ch. 5 Right Gear
Ch. 6 Right Flap (Listed as Aux 1 on Receiver)
Ch. 7 Left Flap (Listed as Aux 2 on Receiver)
Ch. 8 Left Elevator
Ch. 9 Left Gear
System Set Up Mode
To begin setting up the transmitter, press and hold the ENT key, turn the 9303 on, then release
the ENT key.
Model Selection
Press down on the roller with Model Sel highlighted, and select the model you want the P-51 on by
pressing the rolling selector and scrolling through the models. Select the model you want to use by
pressing the roller.
Model Reset
Now press the LIST key and scroll through with the roller until you get to MDL Reset. Press down on
the roller to enter model reset. Press the CLR key, then the bottom key to answer yes.
Model Type Selection
Press the LIST key, scroll with the roller to get to Type SEL and enter type selection by pressing down
on the roller. Scroll with the roller until ACRO is highlighted, and press the roller to select ACRO, and
then press LIST.