User Manual

Now turn the Mixer on using the GEAR switch. Move the Digital Flap Trim lever up or down
to achieve the desired amount of RPM increase. Moving the lever up will increase RPMs and
moving it down decreases RPMs.
Turning the mixer off with the GEAR switch causes the engine to return to Low Idle and turning
it on increases the RPM according to the setting of the Digital Flap Trim.
10. Stop the engine and observe the throttle linkage. Turn the Idle-Up on and advance the Throttle
to Full. Use the TRAV ADJ. Function to adjust/reduce the throttle travel at the high-end if there
is too much throw with the Idle-Up on.
11. To use the mixer for each flight, start the engine and warm it up to normal operating
temperature. Turn the Idle-Up OFF and use the normal throttle trim lever to set the engine to
the lowest dependable RPM. Now turn the Idle-Up on to realize an increase in RPM for flying.
Be sure to remember to turn Idle-Up OFF before attempting to land.
9303 Program Mix Examples 4