User Manual

11. Move the GEAR switch back and forth while observing the number directly to the right of the
program mix name in the upper left portion of the display. The number will change between 0
and 1 as the switch is moved back and forth. When the number is 0, the mixer is looking at the
Pos0 values (not programmed yet) and when it is 1, the mixer is looking at the Pos1 values (also
not programmed). Put the GEAR switch in the position where you want the smoke system to
turn ON. Look at the number directly to the right of the Program Mix name. If it is 0, highlight
and select Pos0 on the display. If it is 1, highlight and select Pos1 on the display.
12. With the GEAR switch still in the ON position, move the throttle stick to full throttle causing
upper Pos value to be highlighted. Set the percentage to +100%.
13. Lower the throttle stick to idle and turn the TX and RX on. Advancing the throttle above ½
should now turn the smoke system on and lowering the throttle below ½ stick should turn the
smoke system off. If it does not, change the mix percentage from +100% to –100% and try
again. Move the GEAR switch to the OFF position and the smoke system should not turn on
regardless of throttle setting.
14. The point at which the throttle stick turns the smoke on and off can be adjusted by highlighting
and selecting Offset. Lowering the Offset value causes the smoke to start at a lower throttle
setting while increasing the value causes the smoke to come on at a higher throttle setting.
9303 Program Mix Examples 2