User Manual

Point Names/Numbers – (Multi-Point Mixer)
The points that can be adjusted are listed vertically by name and are also displayed by
number along the bottom of the graph.
Change the value of a point by highlighting and selecting the point name and dialing-in
the desired percentage.
Current Point Setting – (Multi-Point Mixer)
This list shows the setting for each of the 7 adjustable points (Point-0, 1, 2, 3, 4, 5, 6).
The value of each point determines where the point is positioned vertically on the graph,
which dictates the Slave servo position. The point values can be set from -100 to +100
with -100 being full deflection in one direction and +100 being full deflection in the other
direction. A value of 0 indicates the Slave’s center or neutral position. The overall travel
of the slave channel is determined by the Travel settings described earlier in the TRVL
ADJ. function.
A point value of INH can also be set for points 1, 2, 4, and 5. When set to INH the point
takes on a value represented by the intersection of the cursor and the Curve/Line between
the 2 adjacent points. For instance, if Point-1 is set to -67, Point-2 is set to INH and
Point-3 is set to 0, then Point-2, which is inhibited, takes on a value of -34, which is
midway between points 1 and 3.
The value for a point can be changed by highlighting and selecting the Point Name to the
left of the point value and then dialing-in the desired value.
Pressing the CLR button when a point value is highlighted resets the point to original
settings. The original settings are:
Point-0 -100
Point-1 INH
Point-2 INH
Point-3 0
Point-4 INH
Point-5 INH
Point-6 +100
Cursor – (Multi-Point Mixer)
The cursor appears as a vertical line shows the current Master channel position. When
the Master channel is deflected fully in one direction, the cursor is to the extreme left
over Point-0, when it is at neutral it is in the center over Point-3 and when it is fully
deflected in the other direction the cursor is at the extreme right of the graph over Point-
6.
The cursor moves across the 7 points as the Master is moved from one extreme to the
other. Where the cursor intersects the Curve/Line over a given point defines the amount
of Slave servo deflection, which is equal to the value assigned to the point. For example,
if Point-2 is set to 30% then the servo will deflect 30% from neutral when the Master is
advanced so the cursor is over that point.
JR XP9303 Detailed Function Descriptions 83