User Manual

The Pos0 settings determine how far, and in which direction, the slave channel moves
when the master is moved above and below the Offset (the Master moving in both
directions) when the switch is in a position to select the Pos0 values.
To enter Pos0 values, highlight and select Pos0, move the Master channel control (stick,
lever or switch) in one direction and set the percentage and then move the Master channel
control in the other direction and set its value.
Pos1 Settings – (Std. Prog Mixer)
The Pos1 settings are identical to the Pos0 settings and determine how far, and in which
direction, the slave channel moves when the master is moved above and below the offset
(the Master moving in both directions) when the switch is in a position to select the Pos1
values.
To enter Pos1 values, highlight and select Pos1, move the Master channel control (stick,
lever or switch) in one direction and set the percentage and then move the Master channel
control in the other direction and set its value.
Offset – (Std. Prog Mixer)
The Offset parameter defines the position of the Master where the mixer changes
directions. The Offset automatically defaults to a channel's center position or 0 (zero).
For example, if the Rudder is the Master, the Offset will automatically default to the
center stick position (no rudder input). Since the Offset is at the center, moving the
rudder stick to the left of center causes a mix in one direction while moving the rudder
stick to the right of center causes a mix in the other direction – directions correspond to
the upper and lower percentages for Pos0 and the upper and lower percentages of Pos1.
The amount of mix and actual direction that the slave moves is determined by the
Pos0/Pos1 values. The Offset applies to both Pos0 and Pos1 settings.
The Offset may be changed by highlighting and selecting Offset and dialing-in either a
positive (+) or negative (-) value. A positive percentage moves the offset in one direction
from center while a negative percentage moves the Offset in the other direction from
center.
Available Switches – (Std. Prog Mixer)
There are 4 switches that can always be used to switch between the Pos0 and Pos1
settings (if the upper and lower settings for POS0 or Pos1 are left at 0% the mixer can be
turned on and off with the switch). They include the Aileron D/R switch, Gear Switch,
Rudder D/R switch and the Mix switch. In addition, if Flight Modes are activated in the
Devic.SEL function, then 3 more switch positions may be selected FM0, FM1, and FM2,
which correspond to the 3 positions of the Flight Mode switch.
To select a switch that will switch between the Pos0 and Pos1 values, highlight and select
the switch name and it will toggle between pos0 and pos1. Set the desired switch(es) to
pos1.
Throttle as a Switch – (Std. Prog Mixer)
The throttle stick may also be used as a switch to control the programmable mixer. It can
be used by itself or in conjunction with one or more switches.
JR XP9303 Detailed Function Descriptions 77