User Manual

LIST Button – (Servo Speed)
Press the LIST button to return to the FUNCTION List, or rotate the rotary selector until
LST appears next to LIST and select it to return to the SYSTEM Menu.
ENT Button – (Servo Speed)
Pressing the ENT button returns to the Main Display.
To Change Servo Speeds – (Servo Speed)
1. If there is to be a single set of servo speeds that are in effect all of the time, make sure
the display is showing Pos0. If it is not, select Pos1 and change it to Pos0
Highlight and select the channel and direction for each servo that is to be adjusted.
Once a direction for a servo is selected, the servo speed may be set so the servo
travels from .176 seconds for 60 degrees of rotation all of the way up to 15 seconds
for 60 degrees of rotation. Adjust the speed of each servo until the desired speed is
obtained. That is all that is required when there is only 1 set of servos speeds.
Continue with the next topic.
2. At this point it is assumed that there will be 2 sets of servo speeds that are Flight
Mode or switch selectable. If one set of values is set to NORMAL for all servos,
slowing of servos can be turned off by selecting the position (Pos0 or Pos1) that has
the NORMAL values. Highlight and select Pos0 and change it to Pos1 and then
highlight and select the channel and direction for each servo that is to be adjusted.
Once a direction for a servo is selected, the servo speed may be set so the servo
travels from .176 seconds for 60 degrees of rotation all of the way up to 15 seconds
for 60 degrees of rotation. Adjust the speed of each servo until the desired speed is
obtained. Highlight and select Pos0 and then highlight and select the channel and
direction for each servo that is to be adjusted. Switch between Pos0 and Pos1 to view
and adjust the 2 sets of values of each servo.
3. Scroll over to and select SW SELECT to select the Flight Mode and/or switch that
will be used to switch between the 2 sets of servo speeds. The throttle may also be
used to switch between Pos0 and Pos1 differential settings by highlighting and
selecting THRO STK and setting the percentage of throttle to the point where the
values are switched.
JR XP9303 Detailed Function Descriptions 72