User Manual

SNAP ROLL
The XP9303 has a Snap Roll system that is comprised of a Snap Roll switch that can be used in
conjunction with Flight Modes to select a direction (Right/Up, Right/Down, Left/Up, and
Left/Down) and deflections for Aileron, Elevator and Rudder. Up to four directions and
corresponding rates can be programmed and each Direction/Rate combination can be assigned to
1 or more of the 3 Flight Modes. Pressing the Snap Roll switch causes the aircraft to snap roll in
the direction and according to the rates assigned to the Flight Mode that is currently selected.
If Flight Modes have been activated, 3 of the Snap Roll directions/rate combinations can
assigned to them – one per Flight Mode. If Flight Modes have not been activated, then only one
of the directions/rates may be active and it must be set/selected in the Snap Roll function. The
Snap Roll function is inhibited as a default and must be turned on in order to use it.
If the Snap Roll function is to be used, highlight and select Snap Roll in the FUNCTION List.
The first display shows Snap Roll as Inhibited. Highlight and select INH to activate Snap Rolls
Function
Name
[Snap Roll ]
ENT
LIST
CLR
INH
The Snap Roll function is Inhibited by
default. Highlight and select INH to
activate the Snap Roll function.
If Flight Modes are not activated, only a single direction/rate combination appears at the
lower left of the display.
Function Descriptions 60
[Snap Roll ]
ACT
Function
Name
Pick one Snap Roll
Direction that is to be
active when Flight
Modes are not active
Direction
RIGHT-DOWN
AILE 100% AILE100%
R-D ELEV 100% L-D ELEV100%
RUDD 100% RUDD 100%
AILE 100% AILE 100%
R-U ELEV 100% L-U ELEV100%
RUDD 100% RUDD 100%
Snap Roll
Direction.
Select to
choose a
Snap Roll
Direction &
Rates
Status
Control
Surface
Deflections
for each
Snap
direction
Control
Surface for
each Snap
direction
ENT
LIST
CLR
Direction
Indicator
JR XP9303 Detailed