User Manual

Position 1 Mix Values – (Ail to Rudder Mix)
Shows the amount of Rudder deflection (if any) and direction when the mix is in position
1. To set these values, highlight and select L next to POS1 and set the percentage with
the rotary. Now highlight and select R next to Pos0 and set the percentage with the
rotary.
When the mixer is in the 1 position, the Rudder will deflect the amounts set for Pos1.
Note: The direction of Rudder movement can be changed by using positive (+) values
versus negative (-) values.
Note: if any switch is in the Pos1 position it has priority over switches in the Pos0
position and the Pos1 values will be in effect.
Switches – (Ail to Rudder Mix)
There are 4 switches that can always be used to turn the Aileron-to-Rudder mixer on and
off. They include the Aileron D/R switch, Gear Switch, Rudder D/R switch and the Mix
switch. In addition, if Flight Modes were activated in the Devic.SEL function, then 3
more switch positions may be selected FM0, FM1, and FM2, which correspond to the 3
positions of the Flight Mode switch.
To select a switch that will turn the mixer on, highlight and select the switch name and it
will toggle between pos0 and pos1. Set the desired switch(es) to pos1 and the switch can
now be used to control the mixer.
Note: The mixer can be made to always be on by setting the Pos0 values and not
selecting any switches.
Throttle – (Ail to Rudder Mix)
The throttle stick may also be used as a switch to control the mixer. It can be used by
itself or in conjunction with one or more other switches.
To use the throttle to turn the mixer on and off, highlight and select THRO STK. Now
use the rotary to dial-in a throttle stick percentage/position where 1 = lowest throttle
position and 100 = full throttle position. The throttle trim does not affect the mixer as
only the physical position of the throttle stick is used to turn the mixer on and off.
Note: When using the throttle as a switch, pay particular attention to the Position
Indicator next to the function name in the upper left of the display. It will display "1"
indicating that the Pos1 values are in effect when the throttle stick is below the mix point
set for the throttle and will read 0 when the throttle stick is above the mix point. This is
very important when using the throttle in conjunction with a switch to control the mixer.
JR XP9303 Detailed Function Descriptions 48