User Manual

Function
Name
ENT
LIST
CLR
Pos0: DN 0% Pos1: DN 0%
UP 0% UP 0%
Position 0
Mix Values
[
ELE FLP M
]
Position 1
Mix Values
0-U
Position –
changes
from 0 to 1
when
switch is
moved
Direction –
changes
from U to
D when
Elevator
stick is
moved
FM0 FM1 FM2 AIL GER RUD MI
X
POS1
POS0
THRO
STK
10
Throttle can
also be used
to switch the
mix on and
off.
Switches that can turn the
Elevator-to-Flap mix on and
off or switch between Pos0
a
nd Pos1 values
CLR Button – (Elev to Flap Mix)
Pressing the CLR button while a mix value is selected will reset the value to 0%.
LIST Button – (Elev to Flap Mix)
Press the LIST button to return to the FUNCTION List, or rotate the rotary selector until
LST appears next to LIST and select it to return to the SYSTEM Menu.
ENT Button – (Elev to Flap Mix)
Pressing the ENT button returns to the Main Display.
To Set Up an Elevator to Flap Mix.
1. There are 2 sets of mixing values available. If the Pos.0 values are left at 0% then the
mixer may be turned on and off – Pos.0 will be OFF and Pos.1 will be ON. This can
also be reversed so that Pos0 is ON and Pos1 is OFF by leaving Pos1 values at 0%
and setting percentages in the Pos0 values. Keeping the Pos1 values at 0% and
setting percentages for the Pos0 values is useful when using the throttle stick to
control the mixer in conjunction with other switches.
Highlight and select DN next to Pos0 and set the value to give the desired amount of
Flap travel when full Down Elevator is applied. Direction can be reversed by using
Positive (+) values versus negative (-) values.
2. Highlight and select UP next to Pos.0 and set the value to give the desired amount of
Flap travel when full Up Elevator is applied. Direction can be reversed by using
Positive (+) values versus negative (-) values.
3. Scroll down to the bottom line of the display to select the Flight Mode and/or switch)
that will be used to turn the mixer on and off. The throttle may also be used to turn
the mixer on and off by highlighting and selecting THRO STK and setting the
percentage of throttle to the point where the mixer is to switch between on and off.
Note: The mixer can be made to always be on by setting the Pos0 values and not
selecting any switches.
JR XP9303 Detailed Function Descriptions 46