User Manual

TWIN E.
Dual AILE ELEV RUDD FLAP MATE INH
Mate INH INH INH INH Trim -
Trim - - - AUXT - -
INH GEAR AUX2
A
UX3 - -
[Wing TYPE]
Function
Name
Wing: FLAPERON V-tail: INH
ENT
LIST
CLR
Channels must be INHIBITED in
Devic.SEL before they will appear in
the list as available for Dual channel
use.
Channels Available to use as
a 2
nd
Rudder Channel.
Select one
Trim
The Trim line at the bottom of the display is used to Activate/Inhibit the special trims
associated with the FLAP and AUX3 channels. If FLAP or AUX3 is selected as a Mate,
INH will appear on the Trim Line of the display directly beneath the channel just selected.
This means that the corresponding digital switch (FLAP TRIM or AUX TRIM) located next
to the FLAP and AUX2 switches can be used as additional trims. However, the additional
trims do not function in the same fashion as regular trims. Instead, they trim the controls
such that both channels move in the same direction – like reflexing both ailerons or in the
case of elevator halves, the elevators would move in opposite directions. As a result, these
additional trims should remain Inhibited unless there is a special need for them. If changed
to ACT, the corresponding trim switch (FLAP or AUX3) will become active. If set to INH
these additional trim switches are inactive. Normal trims will trim the additional channel
regardless of the settings on the Trim line of the display.
TWIN E.
Dual AILE ELEV RUDD FLAP MATE INH
Mate INH INH AUX3 INH Trim -
Trim - - INH - AUXT -
INH appears when FLAP or
A
UX3 is selected as a Mate.
Leave it set to INH unless
there is a specific reason to
A
ctivate it.
[Wing TYPE]
Function
Name
Wing: FLAPERON V-tail: INH
ENT
LIST
CLR
Dual channels are automatically trimmed
using the normal trim levers for the c
The Trim line at the bottom is for the special
hannel.
A
UX3 and FLAP trim levers and when
activated, cause the channels to move i
opposite directions than normal.
n
JR XP9303 Detailed Function Descriptions 35