User Manual

ACTIVATE/INHIBIT SWITCHES – Devic.SEL
The XP9303 provides the ability to disable a number of the switches and levers – GEAR, FLAP,
AUX2, AUX3, and AUX4. This is very useful when auxiliary channels are used as Dual
primary flight controls such as using 2 channels/servos for 2 elevator halves and/or using 2
servos/channels to operate the rudder. In this instance, the auxiliary channels are no longer to be
operated by their auxiliary switches but rather the elevator and rudder sticks so the switches must
be Inhibited (INH).
[Devic.SEL]
Function
Name
GEAR FLAP AUX2 AUX3 AUX4
GEAR FLAP AUX2 AUX3 RUDD
SW SW SW LEV D/R
OUT ACT SYS. GYRO ACT ACT
Channels
Switches that
control channels
R
emainder of
the display l
blank for
clarit
y
ef
t
ACT
INH
GYRO
ACT
INH
GYRO
ACT
INH
SYS
Switch/
Lever
Status
ENT
LIST
CLR
Possible Values for
each Switch
ACT
INH
ACT
INH
Note: if any of the channels identified above are to be used as a 2
nd
channel for a primary
flight control (AILE, ELEV, RUDD, FLAP) then be sure to Inhibit (INH) the switches
for the channels in this function or they will not be available to use as a second control
channel in the Wing TYPE function.
Channels
Each of the channels that are controlled by switches and levers are listed across the top of
the display. Beneath each channel is the present switch assignment.
Switches That Control Channels
The present switch assignment for each channel is shown directly beneath each channel
name. The switch assignment for a channel can be changed by highlighting and selecting
the channel above it and choosing another switch from the list of available
switches/levers
Switch/Lever Status
The status of each switch/lever is displayed along the bottom line of the display next to
OUT. To change the status of a switch/lever, highlight and select the parameter on the
OUT line under the channel and keep pressing the rotary to toggle through the available
values - ACT, INH, SYS, or GYRO.
JR XP9303 Detailed Function Descriptions 30