User Manual

SYSTEM Menu
The SYSTEM Menu is obtained by holding down the ENT button while switching the transmitter (TX) on. The
functions contained in this menu are listed below followed by detailed explanations of each function.
INFO-DISP
Model S
MDL
EL
Name
Type SEL
MDL Reset
MODULAT
ENT
LIST
CLR
TRANSFER
TRIM STEP
Devic. SEL
Wing Type
[SYSTEM M.]
INFO-DISP – Information Display (Main Display)
Selecting the INFO-DISP parameter exits in the SYSTEM Menu and displays the Main Menu.
The TX will need to be powered-off and powered back on while holding the ENT button to
acquire the SYSTEM Menu again.
Model SEL – Model Select
Selecting the Model SEL function brings up the Model Selection display. This is where aircraft
are selected from the model memory list and also where the Copy function is found. In addition
to using this function to select a model for programming and/or flying, it should be used to make
a backup copy of existing models where the models are copied to different model memories for
safekeeping.
MDL Name – Model Name
Selecting the MDL Name function obtains the Model Name display. This is where a name is
entered for the current model. This function should be used whenever a new model is set up.
Type SEL – Model Type Selection
Selecting the Type SEL function initiates the Type of Aircraft display. This is where ACRO
(Airplane), GLID (Sailplane) or HELI (Helicopter) is selected for the current model. This
function should be accessed whenever a new model is set up.
MDL Reset – Model Memory Reset
Selecting the MDL Reset function brings up the Reset display. This is where all of the data for
the current model is reset to factory defaults. Data residing in the current model memory is
permanently erased and replaced by default values. This function should be performed before
setting up a new aircraft to insure that all settings start with factory defaults.
MODLAT – Modulation Type (SPCM of PPM/FM)
Selecting the MODULAT function obtains the Modulation display. This is where the
modulation type of the receiver (RX) is identified – either SPCM or PPM/FM. This function
should be accessed whenever a new aircraft is set up. When set to SPCM for a PCM receiver,
the Fail Safe function becomes available in the FUNCTION List.
JR XP9303 Detailed Function Descriptions 3