User Manual

NOTE: When adjusting the analog throttle trim, the total trim travel is actually reduced when set
to less than 100%.
Use a fairly coarse setting such as 4-6 when test flying an aircraft in order to trim the aircraft
quickly and then use a finer setting such as 3-1 for final precision trimming.
Enter the Trim Step function by selecting TRIM STEP from the SYSTEM Menu.
[TRIM STEP]
THRO 100% AUXT 4
AILE 4 FLAP 4
ELEV 4
RUDD 4
Highlight & Select the channel and then
adjust the Trim Step
Function
Name
ENT
LIST
CLR
Trim
Step
Trim
Step
Channel
Channel
Channel
Each trim channel is included in the display. To change the trim resolution for a
particular channel, highlight and select the channel and then adjust the Trim Step value
from 1-10.
Trim Step
Represents the Trim Step value presently in effect for each channel. See the table above
for Trim Step values and corresponding resolutions.
LIST Button
Press the LIST button to return to the list of functions in the SYSTEM Menu, or rotate
the rotary selector until LST appears next to LIST and select it to return to the SYSTEM
Menu.
ENT Button
Pressing the ENT button returns to the Main Display. Once the Main Display is
obtained, the TX will need to be powered-off and then powered back on while holding
the ENT button to get back to the SYSTEM Menu.
TO ADJUST TRIM STEP/RESOLUTION
1. Highlight and select TRIM STEP in the SYSTEM Menu.
2. Highlight and select a channel and adjust the Trim Step.
3. Repeat for other channels as required.
JR XP9303 Detailed Function Descriptions 21