User Manual

TO TRANSFER A MODEL FROM THE XP9303
1. Hold the ENT button while plugging the DSC cord into the back of the transmitter to obtain
the SYSTEM Menu.
Plug the other end of the DSC cord into another XP9303 transmitter while holding the
ENT button down and prepare that transmitter for Receive as described in the next
subsection below. Or, plug the other end of the DSC cord into a DataSafe unit and
prepare the DataSafe for Receive.
Highlight and select TRANSFER in the SYSTEM Menu to obtain the Transfer display.
2. The model to be transferred must be the currently selected model. If the model to be
transferred is not currently selected, use Model SEL in the SYSTEM Menu to select the
model to be transferred to another XP9303 or DataSafe unit.
3. When the receiving device is ready, press the button next to START/CLR on the left side of
the display. The data for the currently selected model is transferred to the receiving device.
RECEIVE A MODEL INTO THE XP9303
The RECEIVE feature is part of the TRANSFER function and is used to transport the contents of
a model memory TO the XP9303 transmitter from another XP9303 transmitter or from a
DataSafe unit.
The RECEIVE function is obtained by selecting TRANSFER form the SYSTEM Menu.
Current
Model
MODEL 15
ENT
LIST
CLR
[TRANSFER]
MODEL 15 ACRO SPCM EXTRA 300S
Function
Name
RECEIVE indicates the XP9303 is to
Receive the model from anothe
r
XP9303 or DataSafe. Select this
parameter to toggle between Transmit
a
n
d
R
ece
iv
e
Message flashes
until the DSC Cord
back of the TX &
TX is powered
OFF.
is connected to the
START
Connect DSC & Power off
START – Press
the button next to
START/CLR to
begin Receiving
the model data.
RE
C
EIVE
Current Model
Memory that is to
Receive the model
from another
XP9303 or
DataSafe
RECEIVE
RECEIVE indicates that the XP9303 is in Receive mode and is ready to receive a model
into the model memory displayed on the screen.
JR XP9303 Detailed Function Descriptions 17