Owner's Manual

1
SYS
mmHg
DIA
/min
AM
1
No
AM
Unit Operation
Unit Operation
23
25
Unit Operation
27
Safety Precaution: If pressure in cuff becomes too extreme
while testing, press the " " button to turn
power off.
The cuff pressure will rapidly dissipate once the unit is off.
Power Off
The " " button can be pressed to turn off the unit
in any mode.
The unit can turn off the power itself about 3 minutes no
operation in any mode.
Press the "MEM" button again, you may check past test results.Upon
activating test results, you can press the"MEM "button to scroll through
all test results stored in memory. The LCD will display the last
memory as NO: 01 reading.
Note: Past test results will only be displayed from the most recently
used memory group. To check past test results in other memory
groups, you must first select the desired group and then turn
monitor off . ( See Select Memory Group on Page 13. )
Unit Operation
26
Memory Deletion
Note: Memory cannot be recovered once it has been deleted.
Memory for a selected group may be deleted while in Memory
Check mode. Press and hold the button 3 second for approximately " "
3 seconds to delete all memory records from the selected group
with voice broadcast " Memory Clear " . And then transfer into
testing mode. Press the button to turn the unit off. " "
1
AM
PUL
Unit Operation
24
With power off, press the " MEM " button to activate
screen display. After the unit performs a self diagnosis, the
screen will display the average test results from the last 3
readings of the last group used . The " " symbol will appear
along with the corresponding WHO Blood Pressure Indicator.
To check the average results from other groups, select the
desired group first prior to activating the " MEM " button
in the off position (See "Select Memory Group" on page 13).
Memory Check and Last 3 Tests Average
AVG
28
Unit Operation
In the power down state, press and hold the button,
and theninstall the batteries. until the LCD screen is full, release
the" " button. When the LCD screen displays the
double zero, the bloodpressure meter is in static state.
Software version is displayed 10 is a software versionin the figure .
" "
Static Pressure Measurement
Note: Only Service personnel permitted to access to this mode, the
mode unavailable in normal use.
1
mmHg
AM
1
SYS
mmHg
DIA
/min
AM
AVG
PUL
1. Download the free “JoyHealth” App: On your mobile phone or table
go to www.sejoy.com.
2.Open the App on your phone or tablet. If requested, you should enable Bluetooth on your
device. You can enable Bluetooth under the Settings menu on your smart phone or table.
3. Create a new user login, or login with your existing user name and password.
4. Selection device “Blood pressure monitor”.
Bluetooth connection
-Using for the first time
Low Battery Indicator
The unit will broadcast " Low Battery"when battery life is depleting
and unable to inflate cuff for testing. The " " appears
simultaneously for approximately 5 seconds prior to shutting off.
No memory loss will occur
throughout this process.
Replace batteries at this time.
If there is arm movement during the measurement, " " may be
shown. Indicates that it may lead to abnormal accurate measurement
results. At this time,the LCD will display " Err".
Arm Shake Indicator