User's Manual

Transmitter Batteries Installation
Receiver Connection Diagram
The transmitter requires 4 “AA” batteries. Do not mix old and new cells. To install the batteries, slide
open the battery door on the bottom of the Transmitter. Install the batteries in the holder as shown in
the diagram (see marks molded inside the case). Make sure to note the proper polarities on each cell.
Close the battery door.
IMPORTANT: Do not operate an R/C model with weak batteries as it could result in reduced range
and/or possible loss of control !
BATT.(5V)
SERVO2(TH.)
SERVO1(ST.)
ESC
Technology Data
2405MHz-2450MHz
100 J
1
6V
2405MHz-2450MHz
:4.8V-6V
180