User's Manual
CAUTION
2.4G Binding
To work your R/C with your models correctly and safely,read this manual carefully and keep it in a safe
way as a reference introduction in the future
Warning:
1.This product is only equipped for radio controlled models.
2.The usage of this product should be approved by local relevant law or regulations.
3.we will not be responsible for the damages caused by unauthorized modification, adjustment or
replacement of parts of this product.
4.The manual maybe altered without prior notice. Please contact us if you have any corrections or
clarifications that should be made in the manual.
Before starting the transmitter, make sure the transmitter batteries are well loaded. The voltage of
transmitter batteries is never lower than 4.5V. And please check and confirm that the servos are all
well and properly connected.
Keep the radio system away from moist, high temperature and strong shake. Do not clean the product
with solvent.
The antenna does not touch anything else when power switch is turned on. Do not leave this product
and its accessories within the reach of small children.
Please use this product according to your local relevant law or regulation, we are not responsible for
any incidents or damages.
The Binding processing
Turn on the transmitter, then connect the power of receiver, pressing the receiver “BIND” button till the
light turn on GREEN which means the binding is successful. After that, it’s unnecessary to bind again.
Caution:
make sure the RX and TX is within one meter, and around 10 meters no similar devices.
If the light flashing, showing the binding failure. Please do again as above indication.