User's Manual

TROUBLESHOOTING
Problem Possible Cause Solution
There is
no reception.
There is sound
but there is no
picture display.
The picture is in
black and white.
There is very
weak reception.
One of the units is not on.
The camera and receiver
are on different channels.
The camera is set to “AV”.
Batteries are low or
improperly installed.
AC adapters are not connected
or electrical outlet is out of order.
The LCD switch on the receiver
is in the OFF position.
Batteries are low or improperly
installed.
Camera is on automatic night
vision due to low light conditions.
The volume is too low.
The units are too far apart.
Make sure both units are on.
Make sure both units are
on the same channel.
Make sure the camera is
set to “camera”.
Check or replace batteries.
Check connections or change
to another electrical outlet.
Make sure the LCD
switch is set to ON.
Check or replace batteries.
If it should not be on night
vision, make sure that the
light sensor on the camera
is not being blocked.
Increase volume level.
Bring units closer together.
10