Operation Manual

8 Special Purpose Tools SUIT 1
9 Specification PAD 1
10 Silicon Oil BOTTLE 1
COMMON FAULT AND THE PROCESSING METHOD
Fault Symptom Possible Causes Solution
When turning on switch
power, the treadmill can not
display when the electric
power is connected.
1. The attaching plug is
not inserted well. 2 .The
electrical head’s attaching
plug is not inserted well.
1. Insert it again. 2. Connect
it once more.
All the display windows
ficker.
The safety switch is not
settled well or damaged.
Put the safety switch on the
correct place or mend it.
It stops by itself when it is
working. And all the displays
are normal.
The automatic system
protection.
1. Press the ‘STOP’ key, then
start it. 2 .Turn off the power
switch, and start it in one
minute.
The running belt can not work
normally, and it has buzz,
with displaying normally.
The enter voltage is too
low.
Please input the voltage
according to the demand.
It is regular when it is running
by itself ,and disordered when
someone walking on it.
Check whether the running
belt is too loose.
Please adjust the running belt
according to the right
method.
It can not display normally or
can not display.
The electrical head can not
work because of the
external disturbance .
Turn off the power switch,
then turn on it in one minute.
Because of some reasons, the technical parameter may has a little difference. So we can not take it as
criterion to measure our state of health, all the data is just as a reference.
Please forgive our not informing the change because of the innovation of the technique.
Please cut off the power immediately and contact with our agents when there is special fault
symptom. We will provide you the best service in time.