Operation Manual

STEP 5

1. Place 50mm square cap (41) into both ends of press bar (15).

2. Install oil bushing (71) into the press bar (15) as shown.

STEP 6

1. Attach press bar (15) to top cross beam (12) with press bar shaft (46) and oil bushing

(71) washer (65) bolt (61) as shown.

2. Attach pec deck pads (28) and hand grip (36) slide onto pec deck arm (16 & 17).

3. Attach handle pipe (43) and hand grip (36) to pec deck arm (16 & 17) with bolt (54),

washer (68) as shown.

4. Install pec deck arm (16 & 17) to press bar (15) with washer (65) and nylon nuts (61) as

shown.