Instructions

ManualsBrandsJoy-it ManualsBreakout BoardsRelay module 1 pc(s)

www.joy-it.net

Pascalstr. 8 47506 Neukirchen-Vluyn

SOLID STATE RELAYS

SBC-SSR01

1. GENERAL INFORMATION

Dear costumer,

thank you very much for choosing our product.

In following, we will introduce you to what to observe while starting up

and using this product.

Should you encounter any unexpected problems during use, please do

not hesitate to contact us.

Caution!

This product may only be installed by a qualified electrician for

your own safety! Working on electric devices/ systems implies

hazard of strokes which may cause serious injuries or even

death!

Summary of content (6 pages)

PAGE 1
SOLID STATE RELAYS SBC-SSR01 1. GENERAL INFORMATION Dear costumer, thank you very much for choosing our product. In following, we will introduce you to what to observe while starting up and using this product. Should you encounter any unexpected problems during use, please do not hesitate to contact us.
PAGE 2
. SETUP WITH THE RASPBERRY PI Raspberry Pi SSR01 5V (Pin 2) DC+ GND (Pin 6) DC- BCM 22 (Pin 15) CH1 BCM 27 (Pin 13) CH2 BCM 17 (Pin 11) CH3 BCM 23 (Pin 16) CH4 - + - + - LOAD LOAD LOAD LOAD Wiring: + - + Caution! The relays can only handle loads from 100 V to 240 V AC and maximum 2 A.
PAGE 3
2. SETUP WITH THE RASPBERRY PI Code example: If the signal pin is set to high, the output is enabled. In the following code example, all output are enabled every 10 seconds for 5 seconds. from time import sleep import RPi.GPIO as GPIO GPIO.setmode(GPIO.BCM) CH1 = 22 CH2 = 27 CH3 = 17 CH4 = 23 GPIO.setup(CH1, GPIO.setup(CH2, GPIO.setup(CH3, GPIO.setup(CH4, GPIO.OUT) GPIO.OUT) GPIO.OUT) GPIO.OUT) try: while True: print ("Enable all outputs") GPIO.output(CH1, GPIO.HIGH) GPIO.output(CH2, GPIO.HIGH) GPIO.
PAGE 4
3. SETUP WITH THE ARDUINO - Arduino SSR01 5V DC+ GND DC- Digital Pin 3 CH1 Digital Pin 4 CH2 Digital Pin 5 CH3 Digital Pin 6 CH4 + - + - LOAD LOAD LOAD LOAD Wiring: + - + Caution! The relays can only handle loads from 100 V to 240 V AC and maximum 2 A. This product may only be installed by a qualified electrician for your own safety! Working on electric devices/ systems implies hazard of strokes which may cause serious injuries or even death! www.joy-it.net Pascalstr.
PAGE 5
3. SETUP WITH THE ARDUINO Code example: If the signal pin is set to high, the output is enabled. In the following code example, all outputs are enabled every 10 seconds for 5 seconds. Before uploading, make sure that you have set the correct board and port in your Arduino IDE. void setup() { Serial.begin(9600); pinMode(3, OUTPUT); pinMode(4, OUTPUT); pinMode(5, OUTPUT); pinMode(6, OUTPUT); } void loop() { Serial.
PAGE 6
4. ADDITIONAL INFORMATION PR Our information and take-back obligations according to the Electrical and Electronic Equipment Act (ElektroG) Symbol on electrical and electronic equipment: This crossed-out dustbin means that electrical and electronic appliances do not belong in the household waste. You must return the old appliances to a collection point. Before handing over waste batteries and accumulators that are not enclosed by waste equipment must be separated from it.