Datasheet

3
Time for more
www.joy-it.net
Published: 04.10.2018
Connection diagram
SBC-CAN01 Raspberry Pi Arduino
VCC 1 (3.3V) 5V
VCC1 2 (5V) 5V
GND 6 (GND) GND
CS 24 (CE0) D10
S0 21 (MISO) D12
SI 19 (MOSI) D11
SCK 23 (SCK) D13
NT 22 (GPIO25) D2
For a Raspberry Pi (and other ARM single board computers) the CAN board requires a voltage of
+3.3V at the VCC connector and a voltage of +5V at the VCC1 connector. With an Arduino, a voltage
of +5V is connected to both terminals (VCC and VCC1).
The terminal resistance can be activated or deactivated at terminal P1.
Via P2, the two signals CanH and CanL can be connected in addition to the screw terminal.
Other informations