Datasheet

CAN Module

with MCP2515 CAN Interface & MCP 2562 Transceiver

Time for more

www.joy-it.net

Published: 04.10.2018

Technical Specifications

Model CAN Module

Arcle No. SBC-CAN01

Chipset MCP2515, TJA1050

CAN Specicaon CAN V2.0B

Communicaonspeed 1Mb/s

Oscillator 8MHz Crystal Oscillator

Terminaon Resistors 120Ω with impedance matching (ensures drive capacity and long-

distance data transmission against signal radiaon)

Interface SPI, CAN

Input Voltage 5V

Power Consumpon 5mA

Standby current 1µA

Operang temperature -40°C - 85°C

Compable to Arduino, Raspberry Pi and other common microcontrollers

Scope of delivery CAN-Module

EAN 4250236817187

PAGE 1
3 CAN Module with MCP2515 CAN Interface & MCP 2562 Transceiver Technical Specifications Model CAN Module Article No. SBC-CAN01 Chipset MCP2515, TJA1050 CAN Specification CAN V2.
PAGE 2
3 Connection diagram SBC-CAN01 Raspberry Pi Arduino VCC 1 (3.3V) 5V VCC1 2 (5V) 5V GND 6 (GND) GND CS 24 (CE0) D10 S0 21 (MISO) D12 SI 19 (MOSI) D11 SCK 23 (SCK) D13 NT 22 (GPIO25) D2 Other informations For a Raspberry Pi (and other ARM single board computers) the CAN board requires a voltage of +3.3V at the VCC connector and a voltage of +5V at the VCC1 connector. With an Arduino, a voltage of +5V is connected to both terminals (VCC and VCC1).