Instructions

Published: 16.08.2019 Copyright by Joy-IT 7
3.2“ / 3.5“ Touch-Display
Now the required "drivers" are downloaded and installed. Here, the Raspberry Pi must be connected to
the Internet. Enter each of the following three commands in the console and conrm each with "Enter".
Commands for the 3.2 "LCD:
Commands for the 3.5 "LCD:
Now you have to install a package for the touch funcon and copy a le:
Restart your Raspberry Pi now:
At the edge of the 3.2 "display are also three buons.
These can be controlled and used via the GPIO.
When pressing a buon, the applied signal is pulled to ground (Acve_LOW).
The buons are connected as follows:
cd /tmp
wget anleitung.joy-it.net/upload/joy-IT-Display-Driver-32b-overlay.dtb
sudo cp joy-IT-Display-Driver-32b-overlay.dtb /boot/overlays/joy-IT-Display-Driver-
32b-overlay.dtbo
cd /tmp
wget anleitung.joy-it.net/upload/joy-IT-Display_Driver-35a-overlay.dtb
sudo cp joy-IT-Display_Driver-35a-overlay.dtb /boot/overlays/joy-IT-Display_Driver-
35a-overlay.dtbo
4. VERWENDUNG DER KNÖPFE
sudo reboot
sudo apt-get install xserver-xorg-input-evdev
sudo cp -rf /usr/share/X11/xorg.conf.d/10-evdev.conf /usr/share/X11/xorg.conf.d/45-evdev.conf
TFT Raspberry Pi
Key 1 GPIO12
Key 2 GPIO16
Key 3 GPIO18